Disassembly
©2010 Viking Preferred Service
21
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Door Handle Removal
Condition Requirements:
Door Lowered
1. Remove two plugs from each side of door assembly.
2. Remove three screws from each door handle end
cap.
Note:
There are set screws that prevent the handle
from spinning in the end caps. It may be
necessary to loosen the set screws before
removing the end caps from the handle. The set
screw is located in the hole that the screws use
to secure the end cap to the door assembly.
3. Pull end cap up then out to remove from handle.
4. Reverse procedure for installation.
Outer Door Panel Assembly Removal
Condition Requirements:
Door Assembly Removed
1. Place the door, handle side down, on a protected
surface.
2. Remove screws that attach the outer door panel
assembly to the inner door panel assembly.
3. Lift the inner door panel assembly from the outer
door panel assembly.
4. Reverse procedure for installation.
Door Hinge Removal
Condition Requirements:
Outer Door Panel Assembly Removed
1. Remove screws, nut and hinge from inner door
panel.
2. Reverse procedure for installation.
Door Logo Removal
Condition Requirements:
Outer Door Panel Assembly Removed
1. Remove two pal nuts and logo from outer door panel.
2. Reverse procedure for installation.
