Disassembly
©2010 Viking Preferred Service
25
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Control Components Accessed
Condition Requirements:
None
1. Remove all surface burner knobs.
2. Remove screws and bezels from control panel
assembly where knobs have been removed.
3. Slide drip tray out and place protective cover on drip
tray.
4. Lift up to remove control panel assembly from four
keyhole screws.
5. Tilt control panel assembly forward rest on drip tray.
6. Reverse procedure for installation.
Indicator Light Removal
Condition Requirements:
Control Components Accessed
1. Hold the red lens and slide off the indicator light. The
indicator light will only slide in one direction.
2. Disconnect two connectors from the indicator light.
3. Reverse procedure for installation.
Control Panel Assembly Removal
Condition Requirements:
Control Components Accessed
1. Mark and disconnect all connectors to remove control
panel from range.
2. Reverse procedure for installation.
Oven Control Removal
Condition Requirements:
Control Components Accessed
1. Mark and disconnect connectors from the oven
control.
2. Remove screws, bezel, and the oven control from the
control panel assembly.
3. Reverse procedure for installation.
