Disassembly
©2010 Viking Preferred Service
31
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
4. Mark and disconnect wires from solenoid coil.
5. Remove gas tubes from solenoid valve.
6. Remove screws and solenoid valve from bracket.
7. Reverse procedure for installation.
8. Perform gas leak test.
Island Trim Removal
Condition Requirements:
Rear of Range Accessed
1. Remove four screws and island trim from range.
2. Reverse procedure for installation.
Backguard Assembly Removal
Condition Requirements:
Rear of Range Accessed
1. Remove four screws and backguard assembly from
range.
2. Reverse procedure for installation.
Side Trim and Side Panel Removal
Condition Requirements:
Control Panel Assembly Removed
Island Trim or Backguard Assembly Removed
1. Remove screws and lift kick plate from keyhole
screws.
2. Remove screws and side trim from range.
3. Remove screws and side panel from range.
4. Reverse procedure for installation.
