12
E-1600-30-IP
Dimensions:
Overall - 127mm x 127 x 57mm (5.0” x 5.0” x
2.25”), Plastic Electrical Box - 102mm x 102mm x 54mm (4.0”
x 4.0” x 2.14”)
Shipping Weight:
1 kg (2.12 lbs.)
Front Panel Material:
14 gauge Marine grade 316 brushed
stainless steel
Connections:
Gel-filled butt connectors
Optional Enhanced Weather Protection (EWP) Available:
The
optional EWP products feature foam rubber gaskets and boots,
sealed connections, gel-filled butt connectors, as well as urethane
or thermal plastic potted circuit boards,
DOD# 859
.
Front View of Optional
VE-5x5 (not included)
2.25”
5.14”
5.22”
3.25”
4.0"
5.0”
Rear View of VE-5x5
(not included)
Condensation
Drain Hole
(2) 0.2 x 0.43 slots
for single gang box
(4) 0.38” diameter holes
3.0” 3.3”
3.0”
2.1”
**** 3/4"
Knockout
for conduit
Wall Stud
Front View of
Plastic Rough-In
Box (included)
Wire knock out
(2) Standard flat head dry wall
(sheet rock) screws (not included)
CONNECTED
(4) 0.2 x 0.43 slots
for double gang box
Laser Etched Graphics
Call Connected Red LED
Marine grade 316 stainless
steel faceplate and push
button switches (sealed
per IP67)
Push to Call Button
Condensation Drain Hole
***Optional Braille Label
(4) 6-32 X 3/4” Marine grade 316 stainless steel, flat head,
T-10 Torx security screws and drive bit (included)
Peel paper liner and adhere gasket to back
of panel, centering over mounting holes.
Caution:
For rough surfaces (ie: brick, stucco,
etc.) additional caulking may be required.
Optional VE-5x5 Surface
Mount Box (left) with black
satin powder paint finish,
not included (DOD 424).
Optional VE-LIGHT kit can
be used to illuminate the
faceplate when used with a
VE-5x5 (DOD 428).
WARNING: Do NOT use a
wet location box.
****Important:
When warm air comes in contact with cold surfaces, such as outside walls and conduits, it causes condensation. To prevent condensation
from accumulating inside the
E-1600-30-IP
always bring conduit into the bottom of the unit. If this is not possible, drill a 1/4” diameter hole in the bottom
of the black plastic box.
Mounting with Plastic Rough-In Box (included):
Flush into
walls, mounts to side of wall stud
Mounting with Optional
VE-5x5:
Surface mount to walls, single gang boxes, double
gang boxes, posts, or to a Viking
VE-GNP
Gooseneck
pedestal.
Important:
The
E-1600-30-IP
will
NOT
mount to a standard
double gang box. If your applications requires a double gang
box, see model
E-1600A-32-IP
above.
*** Important:
Optional Braille “Push for Help” label should
be adhered to the faceplate in ADA applications. Clean
surface with isopropyl alcohol, peel off backing and press
firmly to the front panel in location as shown.
Note:
When European CE compliance is required, mount in optional
VE-5X5
metal enclosure.
