10
E-1600-22-IP
"Old Work" Double Gang Rough-In Box*
(4) Optional Dry
Wall Screws
(not included)
3.65"
Wide
Min.
2.84"
Tall Min.
*
2.25"
Deep
Min.
HELP
INFO
CONNECT
ED
Peel paper liner and adhere gasket
to back of panel, centering over
mounting holes.
Caution:
For rough
surfaces (ie: brick, stucco, etc.)
additional caulking may be required.
(4) T-10 Torx stainless steel,
flat head, security screws
and drive bit (included)
Grade 2 Braille Label
"Help" Push to Call Button
Call Connected Red LED
"Info" Button
Laser Etched Graphics
Marine grade 316 stainless
steel faceplate and push button
switches (sealed per IP67)
(Example: Allied Molded 9312
box shown below, not included)
Dimensions:
Overall - 127mm x 127 x
57mm (5.0” x 5.0” x 2.25”)
Shipping Weight:
1 kg (2.12 lbs.)
Front Panel Material:
14 gauge Marine
grade 316 brushed stainless steel
Connections:
Gel-filled butt connectors
Info Button:
Dials up to 5 non-emergency
phone numbers
Optional Enhanced Weather Protection (EWP):
The optional EWP products feature
foam rubber gaskets and boots, sealed connections, gel-filled butt connectors, as well
as urethane or thermal plastic potted circuit boards. See
DOD 859
.
Mounting in a Double Gang Rough-In Box (not included):
Flush into walls, mounts
to side of wall studs, etc.
Note:
For surface mount installations, use Model
E-1600-20-IP
with
VE-5x5
surface
mount box.
Note:
When mounting outside to rough or uneven surfaces (brick, stucco, etc.) apply
a bead of clear silicone caulking around the top edge and sides of faceplate.
Note:
When European CE compliance is required, mount as shown, in a metal
enclosure.
* CAUTION:
Excessive wire length and/or using a rough-in box with inadequate depth can apply force to the circuit board causing physical damage.
Important:
When warm air comes in contact with cold surfaces, such as outside walls and conduits, it causes condensation. To prevent condensation
from accumulating inside the
E-1600-22-IP
always bring conduit into the bottom of the unit. If this is not possible, drill a 1/4” diameter hole in the bottom
of the double gang box.
