15
E-1600-55-IP
The
E-1600-55-IP
is a universal emergency phone kit for
installing behind elevator panels, or an installation requiring a
custom panel. The finished panel should provide: (4) studs (#6
diameter minimum) for mounting plate, audio holes for speaker
and microphone, a momentary SPST push button switch and a
0.25” diameter mounting hole for the LED. Alternatively, the LED
can be cut off and the wires connected to a integral switch with
LED (often found in elevators).
Black
Black
Clear Spacer Red 5mm Retaining
Lens Round LED Ring
2.0
Diameter
2.25
3.77
4.50
5.0
5.0
4.50
1.76
3.625
Typ.
0.25 Typ.
0.25
Diameter
Plastic Dust Cover (included)
Install prior to fastening the
faceplate to finished panel.
Red "Call Connected" LED with
included mounting hardware
(requires a 0.25" diameter hole)
304 stainless steel speaker and
microphone protection screens
1/16" thick foam gasket (included) for
accoustically sealing mic and speaker to back
of finished panel. Remove backing and adhere
gasket to front panel of the E-1600-55-IP,
centering over speaker and microphone holes
(as shown).
Red (LED
anode)
Black (LED
cathode)
Note:
If you do not want to use the LED,
tuck it inside the unit.
Do NOT cut it off.
Gray (N.C.)
Blue (COM.)
Yellow (N.O.)
2 Amp Relay
Output Contacts
4.0
2.1
(4) Countersunk holes for
mounting the dust cover
(4) 6-32 x 3/4" stainless steel flat
head, 5/64" hexdrive, screws
(included) for fastening dust cover
(4) 0.25 diameter
clearance holes for
mounting the unit
to the back side of
a finished panel.
Additional wire length
may be added if required
(4) 0.25 diameter
holes (not used)
Connect to momentary push
button switch with contact
rating of 50VDC/100mA min
Optional Enhanced Weather Protection (EWP) Available:
The optional EWP products feature foam rubber gaskets and
boots, sealed connections, gel-filled butt connectors, as well
as urethane or thermal plastic potted circuit boards. See
DOD
859
.
Shipping Weight:
.73 kg (1.6 lb)
Connections:
(1) RJ45 10/100 Base-T, (5) gel-filled butt
connectors
Material:
0.062” thick (16 gauge) zinc plated steel
Note:
When European CE compliance is required, mount in
a metal enclosure.
