Page 43
Advanced BIOS Features
Boot Sector Protection
This function protects the BIOS from accidental corruption by unauthorized users or computer viruses. When
enabled, the BIOS’ data cannot be changed when attempting to update the BIOS with a Flash utility. To
successfully update the BIOS, you will need to disable this Flash BIOS Protection function.
You should enable this function at all times. The only time when you need to disable it is when you want to
update the BIOS. After updating the BIOS, you should immediately re-enable it to protect it against viruses.
Full Screen LOGO Display
This item enables you to show the company logo on the bootup screen. Settings are:
[Enabled]
Shows a still image (logo) on the full screen at boot.
[Disabled]
Shows the POST messages at boot.
Quick Booting
Setting this item to [Enabled] allows the system to boot within 10 seconds since it will skip some check items.
Boot Up Num-Lock LED
This setting is to set the Num Lock status when the system is powered on. Setting to [On] will turn on the Num
Lock key when the system is powered on. Setting to [Off] will allow users to use the arrow keys on the numeric
keypad.
IOAPIC Function
This field is used to enable or disable the APIC (Advanced Programmable Interrupt Controller). Due to
compliance with PC2001 design guide, the system is able to run in APIC mode. Enabling APIC mode will
expand available IRQ resources for the system.
MPS Table Version
This field allows you to select which MPS (Multi-Processor Specification) version to be used for the operating
system. You need to select the MPS version supported by your operating system. To find out which version to
use, consult the vendor of your operating system.
