Page 15
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
/
/
M
M
o
o
u
u
n
n
t
t
i
i
n
n
g
g
G
G
u
u
i
i
d
d
e
e
Before you start
First make sure that the power to each piece of equipment is turned off.
Use connecting cables suitable for the equipment to be connected.
The cable connectors should be fully inserted into the jacks. A loose connection may cause hum and other
noise.
To disconnect the cable, pull it out by grasping the plug. Never pull the cable itself.
Refer to the connection guide of the operation manual of the equipment to be connected.
Insert the plug securely into the AC IN socket.
Installation Precautions
When installing the VM032, VM042(H) or VM047 series systems, please follow the precautions listed below:
Power OFF
: When installing the VM032, VM042(H) or VM047 series system(s), make sure the power is off.
Failing to turn off the power may cause severe injury to the body and/or damage to the system.
Qualified Personnel
: Only certified or qualified personnel should install and modify onboard functionalities.
Mounting
: The VM032, VM042(H) and VM047 series systems are heavy devices. When mounting the
system onto a rack, panel, wall or arm, make sure that at least two people are assisting with the procedure.
Anti-static Discharge
: If a user opens the rear panel of the VM032, VM042(H), or VM047 series system to
configure, replace or add peripheral devices, be sure to ground the body first or wear an anti-static
wristband.
Preinstalled Components
The following components are preinstalled in the VM032, VM042(H) and VM047 series systems:
Mainboard
TFT LCD screen
2 x 1GB DDR2 memory module
Wireless LAN module (Optional)
Remote
control
(Optional)
DVD
±
RW drive (Optional)
80GB SATA II hard disk drive
NOTE
Installation or replacement of some of the components is described in the following sections.
Installation and Configuration Steps
The following installation steps must be followed:
STEP 1
Unpack the VM032, VM042(H) or VM047 series system from its box.
STEP 2
Mount the VM032, VM042(H) or VM047 series system.
STEP 3
Connect the main power cord and any other peripheral devices to the bottom connector panel of the
VM032, VM042(H) or VM047 series system.
STEP 4
Turn the power ON and configure the system.
Unpacking
To unpack the VM032, VM042(H) or VM047 series system(s), follow the instructions below:
WARNING!
The front side of the LCD screen has a protective plastic cover attached to the screen. Only remove the
protective cover after the monitor has been properly installed. This ensures the screen is protected during the
installation process.
