Page 36
Component Replacements
The following sections cover the replacement procedures for various components inside the VM032, VM042(H)
and VM047 series monitors. Only qualified personnel should perform the replacement work.
Hark Disk Drive Replacement
Step 1
Remove the mainboard access panel following the
procedures in the previous section.
Step 2
Using a Philips screwdriver, unscrew 4 screws from
the protective housing that holds the hard disk drive.
Once the screws have been removed, lift out the
entire hard disk drive assembly.
Step 3
Using a Philips screwdriver, unscrew the 4 screws
holding the hard disk drive as shown in the drawing
on the left. Once the screws have been removed,
remove the rubber rings holding the hard disk drive in
place. (Be sure to keep the rubber rings in safe place
after removal.)
Step 4
Remove the hard disk drive from the protective
housing.
NOTE
Repeat the above procedures in reverse to install the
hard disk drive.
Memory Module Replacement
The DIMM slots located on the mainboard are used for memory modules. (Please refer to the section on
‘Internal Peripheral Device Connectors’ in previous section to locate the DIMM slots on the mainboard.)
The following types of memory modules can be used:
PC4300 DDR2 RAM (DDR-533)
PC5300 DDR2 RAM (DDR-667)
PC6400 DDR2 RAM (DDR-800)
PC8500 DDR2 RAM (DDR-1066)
Hard disk drive
Protective Housing
