31
GVI Security
3.3.19
Alarm
Detect
When the Alarm Detect function is activated, the camera will detect movement within a monitoring
area and then send an alarm signal automatically. There will be a flash warning notice: MOTION
displayed in the upper left corner of the screen.
DETECT SWITCH
The item is used to enable or disable the ALARM DETECT function.
DETECT MODE
Motion Mode is provided in this section.
MOTION
Motion Detection function allow detecting suspicious motion and triggering alarms
when motion volume in the detected area reaches/exceeds the determined sensitivity
threshold value. The main menu is shown below:
BLOCK MODE
In Motion Detect Mode, users can set Block Mode as “ON” or “OFF”. When BLOCK MODE
is turned on, if there are any variations (e.g. caused by intrusion) in the sections of the
monitoring image, the affected parts will be highlighted dynamically.
FRAME SET
In a monitored field, users can define specific areas as motion detection target zones. Please
refer to the instructions as follows to configure parameters for each motion detection zone so-
called “Frame.” When motion is detected within a defined frame, a flash warning notice:
MOTION, will display in the upper left corner of the screen.
Total four frames can be set. Select a frame using the right/left keys on the keyboard, and press
“ENTER” key to enter the frame’s submenu, as shown below.
