Victoria-05 VITTORIA 10, Инструкция по эксплуатации

Страница: 15 / 28

12.2018 INSTRUCTION MANUAL for installation and operation of pellet stove VITTORIA 8 / VITTORIA 10
15
In Modulation mode, by touching the field showing the current modulation, we can change and set the modulation preset that we
like. If the stove is working in P3 and we touch the field, the preset will change to P2. If touched again, it will change to P1.
It is very important to note that this change is permanent. It is saved and after secondary startup of the stove and
reaching Modulation mode, if P2 is set, the control unit will shift directly to P2and will skip Р3!
12. Maintenance.
Disconnect the power supply of the pellet stove, before performing any activity!
Vacuum clean the combustion chamber before each ignition. If combustion is interrupted, do not start the pellet stove again until
you have emptied and cleaned the combustion chamber.
The wood pellets which are subtracted from the combustion chamber, should not be put back in the pellet fuel hopper!
To operate properly, the pellet stove must be regularly serviced. If you do not perform regular maintenance (thorough cleaning at
least once per season), this may lead to impaired operation of the pellet stove. Any problems arising from lack of cleaning lead to
warranty void.
12.1. Daily cleaning.
For better heat transfer and reduced fuel consumption, it is necessary to perform daily cleaning of the soot in flue channels.
Cleaning once a day is enough. The cleaning have to be made only when the stove is cold.
Picture.5. Picture.6. Picture.7.
Clean the pellet stove with a vacuum cleaner only when it is completely cold. The procedure takes a few minutes.
- Open the fire door and throw away the ashes from the ashtray (Picture.7);
- Remove the combustion chamber or use spatula to scrape off any scales that clog the holes (Picture.6);
- Vacuum clean the combustion chamber and all contact edges;
- Clean the glass when it is cold. If necessary, use appropriate detergent.
- Never vacuum hot coals, because this may damage the vacuum cleaner!
12.2. Weekly cleaning.
- Empty the pellet fuel hopper and clean with a vacuum cleaner if the pellet stove was not used for an extended period.
- Clean the ignition.
12.3. Cleaning ash from the flue channels.
When the pellet stove is not working and cold, vacuum clean the accumulated residue.
The amount of soot depends on the quality of fuel used. If this cleaning procedure is not performed, pellet stove may jam. Upon
completion of the cleaning, make sure that all manholes are properly closed.
12.4. Seasonal maintenance (performed by the installer).
The user has to contact the installer, to perform the seasonal maintenance.
Disconnect the power supply of the pellet stove, before performing any activity!
- Clean pellet stove internally and externally;
- Carefully clean and remove dirt and ashes from the combustion chamber and related divisions;
- Carefully remove the vermiculite plate at the top of the combustion chamber and clean the dirt and ashes;
- Clean dirt and ashes into the flue channels behind the cast iron plates from the combustion chamber. First, remove
the both side plates pos. (B) of Picture.5 and then remove the rear plate pos. (A) by unscrewing the 6 pieces of screws
M 6 x 25. After cleaning the flue channels, put in the reverse order the rear plate pos. (A) and both side plates pos.
(B). The screws must be smeared with a high temperature-resistant graphite lubricant. When installing the rear plate
pos. (A), the joints around the side plates and the pellet feed pipe must be sealed with high temperature resistant
silicone (minimum up to 1000˚C).
- Clean, check and remove all debris from the ignition system;
- Clean propulsion parts and electric motors. Make sure there are no gaps;
- Clean and check the room fan;
A B B