ViAS VENGE, Инструкция по эксплуатации

Страница: 16 / 36

13
„
ALTERNATE ROUTING: Junction A attached to Garmin bracket, Junction B
A
inside down tube.
B
3 4
„
Fig.3: Install a section of brake housing
B
(see chart on page 10 for specific housing
length), starting at the rear brake exit port. It helps to give the cable housing a slight bend
before feeding it into the seat tube exit port. Continue to run the housing into the frame until it
becomes visible at the head tube, then guide it out the top of the head tube.
„ Fig.3 & 4: Route the wires through the chainstay, seat tube (battery and front derailleur) and
down tube, over/in front of the bottom bracket, then connect the wires to the junction B box.
Place the junction B box into the down tube, then install the BB door.
5
„
Fig.5: Apply grease as illustrated to the upper headset bearing, then seat the compression ring
into the upper bearing.
„
Fig.5: Place the brake housing and shift wire into their respective slots in the compression ring.
„ Fig.5: Grease, then place the compression ring into the upper headset bearing, with the arrow
pointing toward the front of the bike.
Avoid tugging on the brake housing to seat the compression ring (Fig.5). Too
hard of a tug will pull the housing out of the compression ring. A bit of excess
housing length in the down tube is ok.
Test the cable housing openings to make sure cables can enter and exit the
cable housing cleanly.