ViAS VENGE, Инструкция по эксплуатации

Страница: 22 / 36

19
3
E
F
F
4
G
„
Fig.3: Place a 3mm Allen key through the brake pivot hole under the brake mount area and
thread the locating bolt
E
into the upper fork mount tab
F
. The bolt does not need to be
torqued, just snugged down lightly.
„
Fig.4: Using a 4mm Allen wrench, tighten the brake pivot bolts
G
from below the brake
mount area. Torque to 55 in-lbf (6.2 Nm).
4. HANDLEBAR/STEM ASSEMBLY
Mechanical shift routing: page 20-23
Electronic shift routing: page 24-27
A. PREPARING FACEPLATE
The faceplace can be assembled either with a Garmin computer mount bracket (S169900005)
(Fig.1), or with a flush mount faceplate cap (Fig.2).
1
Garmin mount
Garmin bracket
Faceplate
Standard bracket Di2 bracket
2
Faceplate
Faceplate
cover
The Garmin mount can be installed with or without a Shimano Di2 junction
box. When using a Shimano Di2 junction box, use the Di2 bracket.
„
To install the Garmin mount bracket, unscrew the two screws on the inside of the faceplate,
then remove the faceplate cap.
„
Place the Garmin mount bracket in the cavity on the front of the faceplate, then reinstall the
two screws. Torque to 25 in-lbf (2.8 Nm).
„
Place the Garmin mount on the bracket, then install the mount using either the standard
bracket (Garmin only) or the Di2 bracket ( Di2 junction box). Torque to 25 in-lbf (2.8
Nm).