ViAS VENGE, Инструкция по эксплуатации

Страница: 31 / 36

28
3
„
Fig.2 & 3: Install the rear brake noodle with ferrule
A
(S160700006) onto the rear brake
cable and the front brake noodle
B
(S160700004) onto the front brake cable. Place the
noodles into the brake slots in the backside of the stem cable guide assembly (side with sheath
flange goes into cable guide holes).
„ Fig.4: Ensure that the expander plug is properly aligned (shim arrow, expander arrow,
expander mark are all aligned toward the front).
„
Fig.3 & 4: Guide the rear brake cable into the rear brake (RB) hole
A
in the compression ring.
Run the cable down into the frame until it exits at the seat tube. As the rear brake noodle starts
to curve downward toward the shim, place the ferrule into the channel in the stem shim until it
bottoms out against the small step.
4
Shim arrow
Expander arrow
Expander mark
Front brake
Rear brake
A
B
„ Fig.4: Guide the front brake cable into the front brake cable guide hole
B
inside the upper
wedge of the expander plug.
„
Continue to guide the front brake cable into the corresponding hole in the lower wedge that is
already aligned with the upper wedge hole (
Chapter 3, Section B, Fig.8, page 17 ). The
cable will go through the lower wedge, through the brake housing in the steerer tube of the
fork, out the housing port above the drive-side brake arm and out the brake cable sheath.
„
Guide the front brake noodle
B
into the front brake cable guide hole until it’s completely seated.