ViAS VENGE, Инструкция по эксплуатации

Страница: 13 / 36

10
2. FRAME ASSEMBLY
Mechanical shift routing: page 10-11
Electronic shift routing: page 12-13
FRAME HOUSING - RECOMMENDED STARTING LENGTH
REAR BRAKE (RED) REAR DERAILLEUR (GREEN) FRONT DERAILLEUR (BLUE)
110cm 165cm 90cm
A. INSTALLING BRAKE / SHIFTER HOUSINGS IN FRAME (
mechanical)
1
RED:
Rear Brake (RB)
GREEN:
Rear Derailleur (RD)
BLUE:
Front Derailleur (FD)
A
C
B
The following housing lengths are for the initial installation, for all frame sizes.
Once routed, the housings must be trimmed according to the instructions.
While order of installation is not critical, it’s recommended to follow the order
below.
„ Fig.1: REAR BRAKE - Slightly curve the leading edge of a section of brake housing
A
(see
chart above for recommended housing length), then insert the housing starting at the seat
tube exit port. Continue to run the housing up the down tube until it exits at the head tube.
„
Fig.1: REAR DERAILLEUR - Slightly curve the leading edge of a section of shift housing
B
(see
chart above for recommended housing length), then insert the housing into the chainstay. Route
the housing over the bottom bracket shell and up the down tube until it exits at the head tube.
„
Fig.1: FRONT DERAILLEUR - Install a section of shift housing
C
(see chart above for specific
housing length) up the down tube until it exits at the top of the head tube.
„ Make sure the cable housings aren’t winding around each other in the down tube. Shine some light
into the down tube from the bottom bracket cable guide hole to make sure they’re not crossing.
„
Make sure the ends of the housings are clean cut with no metal burrs, and that the inner sheaths
have been fully opened using a pick or other narrow object.
„ Install a section of foam tubing over each length of cable housing to ensure the housings don’t
rattle in the down tube.