Vertical SUMMIT IP
Hardware Description and Installation Manual
Issue 1.2
71
Modular Jack Pin Assignment
Table 7.3.2-1 SLT Modular Jack Wiring
Connector
Pin-out
Pin Number
Signal Name
RJ11
1,2
N/A
3,4
TIP, RING
5,6
N/A
7.3.3 LIP Phone Wiring
The Vertical SUMMIT IP supports LIP Phone series. LIP-7008D and LIP-8004D have a
single LAN port that is wired to an Ethernet switch port. Generally all other LIP phone
series shown here have two (2) Ethernet ports, a LAN port and a PC port. The LAN port is
connected to an Ethernet switch port and the PC port is connected to the LAN port of a PC.
The LIP phones are wired to any 10/100 (or 1000) Base-T Ethernet switch port with access
to a VOIP channel. The LIP phones can be powered from a POE compatible Ethernet
switch port or using the AC/DC Adaptor-K.
Caution!
To power your phone, use either PoE or the AC/DC adaptor, not both. Use the Vertical
approved AC/DC power adaptor only. The AC/DC adaptor is ordered separately.
Modular Jack Pin Assignment
Table 7.3.3-1 LIP Phone Modular Jack Wiring
Connector
Pin-out
Pin Number
Signal Name
Function
RJ45
4,5,7,8
Reserved
1
TX+
Transmit Data
2
TX-
Transmit Data
3
RX-
Receive Data
6
RX+
Receive Data
1. Using the above wiring chart, wire the RX and TX pins from the RJ45 Wall outlet, or
equal, for the IP Phone to the appropriate Ethernet switch termination point using
Cat 5 or, for 1000 Base-T Cat 5e UTP cable. The maximum wire length between the
IP Phone and the Ethernet switch port is 100 meters or 328 feet.
2. Use the RJ45 terminated cable provided with the phone to connect the IP Phone
LAN port to the Wall outlet.
3. Connect the PC port to a PC LAN port using a CAT 5 cable terminated on each end
with an RJ45 connector.
4. If not using a POE switch port, connect the DC connector of an AC Adaptor-K to the
DC input on the bottom of the IP Phone and plug the AC plug of the AC adaptor in to
a 100-240 VAC outlet.