Versatile AutoBoom SX275, Руководство по установке

Страница: 28 / 62

Chapter 3
24 Versatile SX275 AutoBoom™ Installation Manual
FIGURE 16.
Machine’s Boom Function Controls
Note:
The S1 coil is located furthest from the machine’s hydraulic valve, and the S2 coil is located
closest to the machine’s hydraulic valve.
11.
Locate the machine’s boom function coils near the machine’s hydraulic valve.
12.
Disconnect the connector from the machine’s left tilt up coil (S1-2 on port SV3).
13.
Install a boom sense adapter cable (P/N 115-0171-546) between the coil and the machine’s coil connector.
14.
Connect boom sense adapter cables between the left tilt down (S2-12 on port SV3), right tilt up (S1-13 on
port SV7), and right tilt down coils (S2-3 on port SV7) and the coil connectors.
15.
On the harness cable, locate the LEFT SOLENOID SENSE connectors. Isolate the connector labeled Up
and connect it to the left tilt up coil via the installed boom sense adapter cable.
16.
Connect the down LEFT SOLENOID SENSE connector to the left tilt down coil via the installed boom sense
adapter cable.
17.
Connect the RIGHT SOLENOID SENSE connectors to the machine’s right tilt up and right tilt down coils via
the installed boom sense adapter cables.
Connect the Harness Cable to the Controller Cable
1.
Route the harness cable (P/N 115-0230-033) toward the machine’s cab.
Note:
Be sure to allow enough slack in the harness cable for boom racking.
2.
Connect the harness cable to the controller cable (P/N 115-0230-007).
3.
Tighten the connector screw cap to secure the connection.
Connect the Controller (If Applicable)
1.
Route the controller cable (P/N 115-0230-007) into the right side of the machine’s cab.
2.
Locate the two controller connectors and connect them to the AutoBoom controller (P/N 063-0130-021).
Connect the Field Computer (If Applicable)
Refer to the Installation & Operation Manual and the specific wiring schematic beginning on page 26 for the
installation and wiring instructions for the specific field computer being used.