Vermont Castings CDVR33n, Инструкция по установке и эксплуатации

Страница: 48 / 68

CDVSC7 & CDV7 Series Gas Fireplace
48
69D3011
CleanInG anD MaInTenanCe
VenT SySTeM
The fireplace and venting system should be inspected
before initial use and at least annually by a qualified field
service person. Inspect the external vent cap on a regular
basis to make sure that no debris is interfering with the
airflow. Inspect entire venting system to ensure proper
function.
GlaSS DooR
Thoroughly clean the inside of the glass door after using
the fireplace for ten hours. Periodically clean the glass
door as necessary.
When cleaning the glass, remember:
•
Do not remove the glass when hot. Allow glass to
cool before removal.
•
NEVER use abrasive materials.
•
Keep children and pets a safe distance away.
•
Never operate the fireplace without the glass door
properly secured.
•
Never operate the fireplace if the glass is broken.
•
Replace any glass that is chipped, cracked, or broken.
Replacement glass door assemblies MUST be supplied
by the fireplace manufacturer – no substitute materi-
als may be used.
•
Handle glass door with care to avoid striking or scratch-
ing it on hard objects.
To clean glass door, follow “Glass Removal” procedure
outlined in the Final Installation section. Film deposit on the
inside of the glass should be cleaned off using a nontoxic,
non-corrosive, non-abrasive, mild-cleaning solution. Simply
apply an adequate amount to the glass and wipe off with
a damp cloth. After all maintenance has been completed,
re-install glass door.
loGS
Leave logs installed in the fireplace for cleaning. Vacuum
surface of the logs with a brush attachment. If logs must be
removed for cleaning, handle carefully by holding gently at
each end. Gloves are recommended to prevent skin irrita-
tion from ceramic fibers. If skin becomes irritated, wash
gently with soap and water. Vacuum surface of logs with
brush attachment or brush logs with a soft bristle brush (i.e.
clean, dry paintbrush). To place logs back in the fireplace,
Refer to “Log Placement” section in this manual.
NOTE: Do not use fluids to clean ceramic fiber logs.
RoCk wool
Replace or add rock wool as required following installa-
tion instructions in the Final Installation section of this
manual.