Verint Nextiva S2700e, Руководство пользователя

Страница: 71 / 101

Verint Video Intelligence Solutions 61
Nextiva S2700e Series User Guide
To reboot the camera with a software tool:
1. Perform one of the following operations:
†
In SConfigurator, go to the Units tab, select the device to reboot, click Configure,
select the Unit entry in the parameter tree, then click Reboot Unit.
†
In the web interface, click Maintenance in the navigation pane, then click Reboot.
The device reboots, while retaining its configuration.
To load the default configuration:
1. Perform one of the following operations:
†
In SConfigurator, go to the Units tab, select the device to reboot, click Configure,
select the Unit entry in the parameter tree, then click Load Default Settings.
†
In the web interface, click Maintenance in the navigation pane. To keep the
network configuration, check Keep Network Settings. Click Load.
This operation will assign the factory default settings to the device (listed in Appendix A on
page 65). Following such a reset, you may need to reprogram the device (for instance, its
IP address and VSIP port) for proper operation within its network.
To perform a hard reset:
1. Remove the dome cover and the inner dome (for the S2700e-VR and S2700eP-VR).
2. Press and hold the Reset button, until the system status LED flashes red very rapidly (it
can take up to 10 seconds).
3. Hold the button for an additional five seconds, until the LED turns off.
The device reboots. It is ready for use with the factory default settings.
4. Put the dome cover and inner dome back.
The device reboots. It is ready for use with the factory default settings.
Presenting the Status LED
Conditions
The system status LED is a bicolor (green-red) LED providing detailed information on the
current state of the device.
Note: The status LED on the S2700e-VR and S2700eP-VR is only visible when the dome
cover is removed.
Condition Indication
Steady red for 5 sec. The device is powering up.
Flashing red (1 sec.
intervals) The IP address of the device is already assigned to another
device on the network.