g)
To reduce the heat input, press the “DOWN / STANDBY” button until the
flame reduces to the low rate heat input setting (3.5kW). If you continue
to hold the “DOWN / STANDBY” button, the burner flame will extinguish,
and only the pilot flame will remain lit. If you wish to turn off the
fire altogether, press the “STAR” / “OFF” button
AFTER THE PILOT FLAME HAS BEEN EXTINGUISHED, IF YOU
WISH TO RE-LIGHT THE APPLIANCE YOU MUST WAIT AT LEAST
THREE MINUTES BEFORE TRYING TO RE-LIGHT THE FIRE.
h)
Should the handset be misplaced, you can turn the fire off by switching
the “ON / OFF” switch to the “OFF” position.
3.5
FITTING THE TRIMS & FRETS (Quasar HE Models)
a)
Fit the outer trim assembly to the firebox with the magnets
provided.
b)
Remove the fret & ashpan cover from the packaging.
Place fret up to the front radiused burner heat shield
c)
Place ashpan cover under fret assembly and centralise.
NOTE : Some models in this range are not supplied with a fret from the
factory, therefore please consult your local retailer for fitting
advice on the type of fret supplied with these models.
33
“STAR” / “OFF” button
“UP” button
“DOWN” / “STANDBY”
button
“LED” handset light
Fig. 37
