22 | Page
Version
00
© Verder Liquids B.V
Ds500, Ds500+ Operating manual
Original instructions (en)
fluids have been used.
Press to confirm that the cartridge has been replaced
A popup will appear to confirm that a new cartridge has been
fitted:
Press to confirm that a new cartridge has been fitted;
the counters will be reset.
or
Press to decline so that the counters are not reset.
10.3.4 Fluid level monitor
This screen allows the operator to set the fluid level monitor
parameters:
Figure 29. - Fluid Level Monitor
10.3.4.1 Supply tank monitor
Use the toggle switch to enable/ disable the data reported on
the main screen.
The following parameters are used to calculate remaining fluid.
10.3.4.2 Maximum
Use the up/down buttons to set the maximum capacity of the
tank you are drawing from.
10.3.4.3 Warning
Set the value(%) at which the main screen warning should
appear.
NOTE:
The pump will not stop automatically when 0% is
reached.
10.3.4.4 Current
Set the value of what is currently in the tank.
10.3.5 Security settings
This screen allows for a screen lock to be enabled/ disabled,
adjustment of time before the screen lock activates and whether
a PIN code should be entered to unlock the screen:
Figure 30. - Security Settings
•
Screen lock
If enabled, the Operating screen can be manually locked /
unlocked.
•
Automatic lock timeout:
Adjust delay before the screen automatically locks.
•
Pin Code Request:
Enable/ disable pin entry to unlock screen.
Change system PIN code
Press to change the pin code; a popup numeric keypad will
be displayed where the operator will be required to enter the
current PIN code (default 1111):
Figure 31. - PIN code entry
Now a new PIN code can be entered.
Re-enter the PIN code then accept to continue.
10.3.6 Pump information
This screen displays information about the pump and allows
configuration of Pump Label and Language along with access
to the Diagnostics, Software and Factory Reset screens:
Figure 32. - Pump Information
