14 | Page
Version
00
© Verder Liquids B.V
Ds500, Ds500+ Operating manual
Original instructions (en)
–
Press to stop the pump
also
–
Hold during boot to update firmware from USB device,
Start
–
Press to start the pump
also
–
Hold during boot to start touch calibration procedure,
Discharge point (out)
–
Fluid outlet, M24 threaded connector to be used with tube
connection kit (supplied)
Breather point
–
Pressure relief in the unlikely event of a hose burst - do
not obstruct!
It is recommended that the hosetail connection is fitted to
aid with any fluid capture.
Cartridge
–
Replaceable cartridge which facilitates non-contact fluid
transfer.
Suction point (in)
–
Fluid inlet, M24 threaded connector to be used with tube
connection kit (supplied).
Cartridge lock
–
Engages and locks the cartridge in position.
External control input
M12, 5 pin, B coded socket
–
Digital control: Run/ stop, external contact
–
4-20mA speed control input
External control output
M12, 5 pin, A coded socket
–
Digital control: Alarm, pump running conditions
–
4-20mA speed indication output
Mains input
–
Pre-fitted mains cable with moulded plug (not user
serviceable) for connection to a suitable mains supply 100-
240 VAC.
7.3.2 Rear
Figure 5. - Ds500 rear
Table 11. -
Item
Description
Item Description
1
PAT connection
earth point (M4)
2
USB port
3
IP66 vent
Layout (rear)
CAUTION
Portable Appliance Test (PAT) connection earth point
–
Earth connection used only for testing.
USB port
–
Covered USB port for firmware updates.
NOTE:
in order to maintain IP integrity, the USB cover
must be fitted when the port is not in use.
Vent
–
Ensure there is unobstructed free space around the unit
so as to maintain optimum air flow and heat dissipation.
Ensure recommended ambient temperature is within
Verder recommendations - see 6.4.1 Ambient.
1
2
3