Solution Bottle. Once the Buffing Solution Bottle
has been refilled, the Operator will need to press
the “Regular” and then the “Blu-ray” buttons
on the User Keypad, to inform the unit that
the refill has been performed. At this point the
“CC” message will disappear. Note: The CC error
message is also an indication to clean out the
Catch Tray. Upon completion, the machine will
reset back to the Main Function Mode, and the
User can now continue with operation.
WARNING: FAILURE TO REFILL THE BUFFING SOLUTION BOTTLE WILL RESULT IN
INFERIOR REPAIR QUALITY AND IN SOME EXTREME CONDITIONS CAUSE DAMAGE
TO THE DISC AND TO THE MACHINE!
Replace Buffing Pads & Center Hub:
Over
time, the buffing pads will wear down. Each
set of Buffing Pads, are rated for 84 minutes of
operation. It will take six sets of Buffing Pads to
equal the 500 minute rating on the C-H Chip. For
this reason the VMI Hybrid has been designed to
notify the Operator to replace the Buffing Pads.
After 84 minutes of machine operation, the Main
Screen on the User Keypad will display the “CP”
message indicating that the Buffing Pads must
be replaced.
The “CP” error message is also an indication to
replace the Center Hub. Over time the Center
Hub will wear down and as a result this hub will
loose its effectiveness. In order to protect the
inside diameter of the discs from collecting any
residue during the repair process, the Center
Hub must be replaced.
Once the new Buffing Pads and the Center Hub
has been installed, the Operator will need to press the “Regular” and then the “Blu-
ray” buttons on the User Keypad, to inform the unit that the replacing has been
performed. At this point the “CP” error message will disappear. Upon completion,
the machine will reset back to the Main Function Mode, and the User can now
continue with operation.
WARNING: FAILURE TO REPLACE THE BUFFING PADS WILL RESULT IN INFERIOR
REPAIR QUALITY AND MAY CAUSE DAMAGE TO THE OPTICAL MEDIA!
SECTION 4
Modes of Operation
9
