Velasa Sports Sparx ES100, Руководство по эксплуатации

Страница: 24 / 208

OPERATION
20
GOALIE SKATES
To watch the How-To video, visit
sparxhockey.com/loadgoalie
If your goalie skate has a cowling (the plastic
protective area that sticks out from the boot),
you must first install the Goalie Risers onto
the
Skate Clamp
(one
Goalie Riser
on each
side of the Skate Clamp ). Each Goalie Riser
has two Anchor Pins (A) as shown below.
A
If your goalie skate does NOT have a cowling,
do not utilize Goalie Risers and move on to
step 2.
1
INSTALL THE GOALIE RISERS
Align the Anchor Pins of the Goalie Risers
to the Anchor Slots of the Skate Clamp .
Once aligned, press down firmly until you
feel the Goalie Risers snap into place.
2
CONTINUE THE SHARPENING
PROCESS
Refer to “Loading a Skate” in the
Operation section of the manual. When
adjusting the Grinding Ring Height , refer
the graphic in step 3.
3
ADJUST THE GRINDING RING
HEIGHT
Refer to “Adjusting the Grinding Ring
Height” in the Operation section of the
manual using the figure below as your
guide where the desired contact point is
A, contact point B is too high and contact
point C is too low.
A
B
C
A
4
CONTINUE THE SHARPENING
PROCESS
Refer to “Sharpening Skates” in the
Operation section of the manual.
5
REMOVE THE GOALIE RISERS
Pull up on each end of the
Goalie Risers
to
remove from the Skate Clamp .