Velasa Sports Sparx ES100, Руководство по эксплуатации

Страница: 21 / 208

OPERATION
17
3
MOVE THE CARRIAGE INTO
POSITION
Using the l
Left
and r
Right Buttons
on
the Keypad , back the Grinding Ring off the
toe of the skate blade 1/4 inch.
A
4
ADJUST THE GRINDING RING
HEIGHT
Open the Glass Door . Locate the red h
Height Adjustment Knob (A). Turn the
knob left to raise the height or right to
lower the height until the Grinding Ring is
at the desired height. The knob is labeled
1-8, with 8 being the highest setting for
the Grinding Ring and 1 being the lowest
setting.
A
5
INSPECT THE CONTACT
POINT
Close the Glass Door . Once the Glass Door
has been closed, using the l Left and
r Right Buttons , touch the Grinding Ring
to the skate blade. Inspect its contact point
and be sure it is in its desired position.
Repeat steps 4 and 5 until the
Grinding
Ring makes contact at the desired position.
6
END MOVE MODE
Press the
m Move Button
again to send the
Grinding Ring back to its home position.
SELECTING THE NUMBER
Of CyCLES
To watch the How-To video, visit
sparxhockey.com/cycle
When the sharpener moves the Grinding
Ring out and back over the skate blade
once, it is called a cycle.
The Sparx™ Sharpener comes set
automatically to a standard
4 four cycles
with all standard Radius Ring™ and FIRE
Ring™
Grinding Rings
. We recommend
trying four cycles to start and moving
higher or lower as needed. Typically, we
have found that four cycles will handle
normal wear and tear (and even small
nicks) from one to four hours of skating
between sharpenings. For brand new steel
or when changing Grinding Ring hollow
depths, we recommend using the 1
10-cycle setting to ensure you completely
reset the skating surface of the blade. See
Sharpening New Steel at the end of the
Operation section.
1 ADJUST THE CYCLE COUNT
Use the l Left and r Right Buttons (A) on
the Keypad to adjust the number of cycles
desired. The number of cycles selected will
be illuminated on the Cycle Counter (B).
B
A