Velasa Sports Sparx ES100, Руководство по эксплуатации

Страница: 30 / 208

TROUBLESHOOTING
26
TROUBLESHOOTING
26
ERROR CODES
ERROR
CODE
CAUSE CORRECTIVE ACTION
1 - 2 - 4 Glass Door open. Close Glass Door .
1 - 2 - 5
Excessive Glass Door
opening during alignment.
Attempt alignment again while leaving Glass Door
closed until Carriage stops at alignment location.
1 - 2 - 6
Dust Tray
missing. Confirm that
Dust Tray
is correctly installed.
1 - 2 - 10
Air Filter
missing. Install
Air Filter.
1 - 3 - 10
Attempted to start
Alignment Mode with skate
or Grinding Ring installed.
Remove skate and install
Alignment Ring
.
1 - 4 - 5
Pressed the p Play Button
in Alignment Mode .
Exit Alignment Mode by pressing the c Alignment
Button or n Cancel Button prior to pressing the
p Play button.
1 - 4 - 6
Pressed the p Play Button
in Move Mode .
Exit Move Mode by pressing the m Move Button or
n Cancel Button prior to pressing the p Play button.
1 - 5 - 10
Left Protective Slot Cover
disengaged.
• Adjust skate and Protective Slot Covers until
contact is made between Protective Slot Covers and
both ends of the installed skate. LEDs on Protective
Slot Covers
should be extinguished.
• Use
Youth Skate Adapters
if skate is too small to
make contact with both Protective Slot Covers .
1 - 6 - 10
Right Protective Slot Cover
disengaged.
• Adjust skate and Protective Slot Covers until
contact is made between Protective Slot Covers and
both ends of the installed skate. LEDs on Protective
Slot Covers should be extinguished.
• Use Youth Skate Adapters if skate is too small to
make contact with both
Protective Slot Covers
.
2 - 3 - 6
Sharpener failed to detect
skate.
Ensure that skate is installed in the Skate Clamp
correctly and the Grinding Ring height is adjusted
properly.
2 - 4 - 6
Grinding Ring has
insufficient life remaining
for selected sharpening
operation.
Sharpener will reset Cycle Count to maximum
available cycles. Run sharpener with the new value or
lower.
2 - 4 - 10 Grinding Ring empty. Install a new Grinding Ring .
2 - 5 - 6 Grinding Ring not found. Install a valid Grinding Ring .
2 - 5 - 10
Grinding Ring read
incomplete.
Repeat process and allow extra time between steps.
If this does not resolve the problem, replace the
Grinding Ring .
2 - 6 - 10 Grinding Ring read error. Install a valid Grinding Ring .
3 - 5 - 10 Grinding motor overcurrent.
Confirm that the Grinding Ring height is adjusted
properly and nothing is obstructing the Grinding
Ring .
3 - 4 - 10
Hardware Fault Circuitry
failure.
Talk to a Sparx Customer Service Representative at:
sparxhockey.com/support
3 - 6 - 10
Translation Error - Limit
undetected.
Confirm that the Carriage is not obstructed.
4 - 5 - 10 File System Incompatibility.
The installed Grinding Ring is not compatible with the
skate sharpener. Install a valid Grinding Ring.
4 - 6 - 10 Tag Error Log Failure.
Talk to a Sparx Customer Service Representative at:
sparxhockey.com/support