Instruction Manual
VLB-92 Omni Mega LED Beacon
© Sabik Oy, Dec 2018
VLB-92 Omni Mega LED Beacon
Page 41 of 56
VLB-92 V1.19
specific day/night thresholds (DNT). Values in the range 100-112 define day and night operation
(ODD) and specific day thresholds in the range 0-12 (DNT).
Parameters:
Address: Address of unit (0
– All units,1 = Master Unit)
Bool (100s) + DayNightArr1 (units) : Refer to DNT for vaid Index values and ODD for the
effect Boolean shifted to the 100s position.
Operation Mode
<OPM> Address, Mode/
Parameters:
Address: Address of unit (0
– All units,1 = Master Unit)
Mode:
0
Normal Operation
5
Test Beacon On
6
Test AIS Beacon On
7
Test Alarm (Beacon Fail)
8
5 minute test mode
Battery Low Threshold
<BLW> Address, Voltage/
Parameters:
Address: Address of unit (0
– All units, 1 = Master Unit,2 = Slave 1 or 3 = Slave 2)
Voltage*10: Battery low voltage threshold (beacon ceases operation if incoming power voltage is
below this number). Range 0 to 24.0volts (0 to 240) for the 24V version or 0 to 12.0 volts (0 to 120)
for the 12V version (MAX_BATTERY_LOW).
Note: Even if the battery low threshold is set to 0, if the beacon sees a voltage drop below 15 volts
for the 24V version or below 9.8 volts for the 12V version immediately after turn on for 5 cycles,
the beacon will stop operating until reset (manually or through day/night transition) or battery high
threshold is exceeded.
Battery High Threshold
<BHI> Address, Voltage/
Parameters:
Address: Address of unit (0
– All units, 1 = Master Unit,2 = Slave 1 or 3 = Slave 2)
Voltage*10: Power supply voltage level where beacon will resume operation after experiencing a
battery low shutdown. Range 20.1 to 28.0 volts (201 to 280) for the 24V version or 10.1 to 14.0
volts (101 to 140) for the 12V version (MIN_BATTERY_RESTART to
MAX_BATTERY_RESTART).
Beacon will reset upon battery recovery.
Software Version
<VER> Address, VersionNumber/
Parameters:
Address: Address of unit (0
– All units,1 = Master Unit)
VersionNumber: Software Version Number
Configuration Serial Number
<CSN> Address, SerialNumber/
Parameters:
Address: Address of unit (0
– All units,1 = Master Unit)
SerialNumber: Serial Number for the factory loaded configuration parameter table. Distinct from
the Beacon Serial Number. Range 0 to 65534
Security PIN Number
<PIN> Address, PinNumber/
Parameters:
Address: Address of unit (0
– All units,1 = Master Unit)
