Instruction Manual
VLB-92 Omni Mega LED Beacon
© Sabik Oy, Dec 2018
VLB-92 Omni Mega LED Beacon
Page 15 of 56
VLB-92 V1.19
5.2
Default Settings
The Omni Mega is delivered from the factory with default settings including the range and flash
character required for the application. These settings are detailed in Appendix A. If there is a
need to return the light to the default settings use the Reset Factory Default option (8-1-000).
5.3
Programming Syntax
All programming of uses the syntax of: OPERATION_FEATURE_VALUE
There are six OPERATION functions:
Programming
Operation 1
Creating a Custom Character
Operation 2
System Information
Operation 3
Optional PIN code
Operation 7
Other settings
Operation 8
Read settings
Operation 9
FEATURE items represent the features of the light such as flash character and intensity.
VALUES are the actual settings or value of the various features.
Appendix A of this manual provides a Table for the programming features of the Omni Mega.
Please take the time to become familiar with the table before continuing.
5.4
Visual Feedback when Using the TVIR Programmer
The Omni Mega will provide visual feedback of the programming instructions it receives from the
TVIR programmer. It is important to understand the feedback that is provided to ensure the light
will be programmed correctly.
Note:
The default operation of the Omni Mega is for the visual feedback to be provided from a green or
blue LED in the bottom lens of the beacon. If the green or blue LED is not bright enough to see
the visual feedback the main LEDs can be used for providing the visual feedback. See Section
5.5.11. When the main LEDs are used to provide the visual feedback their intensity is reduced to
4% of the maximum intensity of the Omni Mega.
Programmer Keys
Light response
Enter Programming Mode
By pressing red standby key for 5 seconds
4 quick flashes (0.1sec on 0.1sec off)
.
Numeric key when programming
1 flash for each key pressed
When programming code recognised
The 3 or 4 digit value code is repeated using a
series of flashes of 0.1sec on and 0.1sec off
with a gap of 0.5sec between each number of
the code. A zero is represented by a 2 second
on flash.
Proper termination of custom character
programming: the feedback code will be 000
When programming code
is not
recognised
3 quick flashes (0.1sec on 0.1sec off)
The light will remain in programming mode
waiting for a new programming instruction.
