Introduction
Safety Warnings
5
Safety Warnings
Veeder-Root maintains a continuous process of product development and therefore product specifications may
not be as described in this manual. Please contact the Veeder-Root office nearest you, or visit our website at
www.veeder.com
for information on new or updated products. Changes affecting products or procedures
described in this manual will be reported in subsequent revisions.
Veeder-Root has taken every care in the compilation of this manual; however, it is the installers’ responsibility to
take every precaution to safeguard themselves and others. Every person working with Veeder-Root equipment is
expected to take every safety precaution possible and to have read this manual.
Deviation from the specifications contained in this manual can result in rework, delays in system
installation and additional installation charges.
Contractors are advised to contact their nearest Veeder-Root office where local conditions may
preclude using the specifications contained in this manual.
VaporTEK Configurations
VaporTEK is available in four different configurations depending on required A/L (air to liquid) performance,
compatibility with localized A/L monitoring requirements and performance A/L thresholds.
• VaporTEK Basic
- Constant Speed System controlled High Voltage Signals M1/M2, (No A/L – Control)
•
VaporTEK Plus
- Variable Speed System, A/L controlled by fuel flow (electronic signal is required)
• VaporTEK Enhanced
- Constant Speed System controlled High Voltage Signals M1/M2, (MPV A/L - control)
• VaporTEK Ultra
- Variable Speed System, A/L equalized by EPV (electronic signal is required)
WARNING
This product is to be installed and operated in the highly combustible environment of
a gasoline dispenser where flammable liquids and explosive vapors may be present.
FAILURE TO COMPLY WITH THE FOLLOWING WARNINGS AND SAFETY
PRECAUTIONS COULD CAUSE DAMAGE TO PROPERTY, ENVIRONMENT,
RESULTING IN SERIOUS INJURY OR DEATH.
The following hazards exist:
1. Electrical shock resulting in serious injury or death may result if power is on
during installation and the device is improperly installed.
2. Product leakage could cause severe environmental damage or explosion
resulting in death, serious personal injury, property loss and equipment damage.
Observe the following precautions:
1. Read and follow all instructions in this manual, including all safety warnings
before installing this equipment.
2. Before installing this device, turn Off, tag/lock out power to the affected
dispenser, including submersible pumps.
3. Evacuate of all unauthorized persons and vehicles from the work area.
4. To protect yourself and others from being struck by vehicles, block off your work
area with cones, safety tape or barricades during installation or service.
5. Do not operate this equipment in hazardous locations with any securing screws
or covers removed. Comply with all applicable codes including: the National
Electrical Code; federal, state, and local codes; and other applicable safety
codes.
OFF
