Vauxhall Signum, Руководство пользователя

Страница: 44 / 310

39 Keys, doors, windows, sun roof
Programming the universal radio control
system for variable code systems
1. Perform basic programming – see
previous page.
2. Activate synchronisation mode of
system (see system manufacturer’s
system operating manual) and briefly
press the pre-programmed button on
the universal remote control three times
within 30 seconds.
3. The radio control system is now
programmed for variable code systems.
To program other systems for variable
codes, repeat steps 1 and 2 for the other
buttons of the universal remote control
system.
Using the universal radio control system
With the ignition on, press the required
universal radio control button, and the
control indicator in the mirror housing will
illuminate. The pre-programmed system
can now be operated using the universal
radio control system.
Reprogramming individual button
settings
If a button that has already been
programmed is to be used for a different
system, repeat steps 3 to 5 of the basic
programming procedure described
previously.
Clearing down all programmed button
settings
Before selling the vehicle, it is a good idea
to erase button settings.
Button settings can only be erased all at
once. It is not possible to erase individual
button settings. Buttons can, however, be
individually reprogrammed, see
"Reprogramming individual button
settings".
In order to erase the programming of all
3 buttons, press both outer buttons and
release as soon as the LED begins to flash
(after approx. 20 seconds). All button
settings have now been cleared and can be
programmed anew at any time.
Note
Keep replaced manual transmitters for
possible reprogramming. The manual
transmitters can also continue to be used.
If, after repeated attempts at execution of
the above steps, a system cannot be
actuated with the universal remote control,
seek the assistance of a workshop.
During programming, the vehicle should be
within the range of the receiver. Under no
circumstances should the vehicle be in the
movement zone of a system (e.g. garage
door).
Do not program a system without an
automatic safety stop (manufactured
before April 1982).
Take note of the system manufacturer’s
safety instructions for drives and manual
remote control units.