VARCO PRUDEN SSR 900, Руководство пользователя

Страница: 14 / 24

THREADED BOLT
SET SCREW
WAHERS
NUT
LOCK NUT
SEAMER TOOL
CLAMPING
BLOCK AREA
HANDLE
1. If clamping handle is loose and will not clamp, tension has been lost. Check nuts above
washers on turnbuckle bolts. Tighten to "snug", then turn (min. 1/4 turn or max, 1/2 turn)
to tighten or reset properly (see item #7 for alignment).
2. If any worn, broken or bent parts are noticed that hold linkage in and around the adjustable
turnbuckle, contact Customer Service at the VP Buildings Service Center for the rerquired
repair method.
3. When checking tool prior to seaming and during seaming operation, check to see if set
screws at bottom of rolls are tight. Roll may drop down during seaming and damage panel
seam if screws are not tight.
4. If forming roll looks like it has dropped down, but set screw at bottom is tight, do not
remove top plate cover. Contact Customer Service at VP Buildings Service Center for
maintenence procedure.
5. If there are electrical problems with the seamer tool, notify VP Buildings Service Center.
Always have electrical work performed by a qualified electrical repairman.
SET SCREW
IS LOOSE
FORM ROLL
HAS DROPPED DOWN
Model No. VP-900
*TURNBUCKLE
CLAMPING HANDLE ASSEMBLY
11
6. FIELD MAINTENANCE/TROUBLESHOOTING