E5 Series High Performance Universal Inverter User’s Manual
Chapter 4 Operation Panel
31
4.3 Description of Keys on Operation Panel
Note:
The press down the knob of shuttle type operation panel is equivalent to PRG Key.
Pressing PRG key continuously can realize browse of all parameters.
Symbol
Name
Function
Key type
Shuttle type
Programming key
PRG
T
．
Enter each level of menu
T
．
Confirm displayed data storage
3
．
Check parameters in sequence
4
．
Confirm changeover of the run command channel with M key
Escape Key
ESC
T
．
Back to first level menu from second level menu; Back from first level
menu to standby status, running status, and fault status from first
level menu
T
．
Give up data storage after modifying data
3
．
Back to all parameters displayed mode after pressing this key for
more than 5s. Refer to 4.4.3. When LCD cannot display all the
parameters, use this method to re−display all the parameters
4
．
After pressing >> key to switch from fault display to Stop T Run
parameters display, press ESC to back to fault display status
Knob+
Knob−
Increase Key
∧
T
．
In first level menu, increase parameters according to edit bit
T
．
In second level menu, increase the parameters value
3
．
In stopTrun status, increase the frequency reference or PID main
reference
Decrease Key
∨
T
．
In first level menu, decrease parameters according to edit bit
T
．
In second level menu, decrease the parameters value
3
．
In stopTrun status, decrease the frequency reference or PID main
reference
Shift Key
>>
T
．
In first level menu, press >> key to select edit bit of PX.YZ menu
T
．
In second level menu, press >> key to select the edit bit of data
3
．
In stopTrun status, press >> key to display parameters such as
frequency, DC BUS voltage, current and voltage, etc.
4
．
In fault status, change from fault display to stopTrun display
Run Key
RUN
T
．
When running command is given via operation panel, the key is used
to start the motor
T
．
After setting the motor data identification, press RUN key to start
motor data identification
StopTReset Key
STOPTRST
T
．
When running command is given via operation panel, the key is used
to stop the motor
T
．
This key is used as a stop key when inverter has fault alarm but not
stop
3
．
When the inverter has fault and stopped, this key is used as RESET
key to clear the fault alarm
Multi
−
function
selection Key
M
See table 4−T for the using method of multi−function selection M key
function selection and the meanings of MULTI indicator
ForwardTReverse
Key
FWDTREV
When running command is given via operation panel, this key is used to
change the output direction of motor
Содержание E5 Series
