164 bright blue Installation Manual
9
Go to the
Link
tab.
10
Use the
Select Door
drop down menu to Set the address of the WRI400. This number will be the
WRI400's address.
11
Click
Link
.
12
Make sure power is connected to the WRI400.
13
Remove the WRI400 cover.
14
Press and
hold the WRI400’s
LINK
button until the RX/TX LED blinks red and green.
15
When linking is successful, the RX/TX LED will blink to indicate the quality of the RF link.
▪
Solid green, fast green blinks, or green with very few red blinks = Good link
▪
Solid red or fast red blinks = Poor or no link
Note:
The WRI400 will fail to link if it is not in RF range of the PIM400.
Additional Configuration
Once the WRI400 has been linked and addressed the Heartbeat, Request to Exit, and Door Position Switch
options need to be configured. Follow the steps below to finish the configuration:
Connect the WRI400 to the HHD
1
Using the USB cable, connect the HHD to
J5
on the WRI400.
2
Start the SUS application.
3
Log into the SUS (default password is 123456).
WRI400
will be displayed at the bottom of the screen after
a short delay.
4
You are now ready to configure the WRI400.
