www.vanco1.com
800.626.6445
14
CONTROL LOCAL DEVICE LOCALLY
Connect IR receiver(s) to IR IN port of 4K HDBaseT 4x4 Matrix Switcher, and IR Emitter(s) to IR OUT port of
the switcher, and use the IR Remote of local source to control.
Connect an IR receiver to IR IN of local matrix, and an IR Emitter to IR OUT port of the switcher. Use the IR
Remote of local source to control the device locally. See below:
Note: Send command “%0901.” to enter infrared carrier enforcing mode if the IR Receiver connected is not
with carrier.
The IR signal is sent by corresponding IR remote, then it is transferred to corresponding zone of the matrix,
finally it is transferred to IR OUT port and received by controlled device.
Switching Operation:
(4 IR IN ports correspond with 4 HDMI input ports separately in default mode.)
a) Sending command (reference to RS232 Control): [x1]R[x2].
x1: Corresponding to the 4 IR OUT ports of the matrix, the IR transmitter connected to this port can be
placed at IR receiving area of output device or 4K HDBaseT 4x4 Matrix Switcher itself.
x2: Corresponding to the zone (receive IR signal from HDBaseT receiver with IR IN port connects with IR
receiver) number of 4K HDBaseT 4x4 Matrix Switcher.
Example: Send command “3R2.” to transfer IR signal received from zone 2 to IR OUT port 3.
