www.vanco1.com
800.626.6445
12
CONTROLL FAR-END DEVICE LOCALLY
Connect an IR receiver to IR IN/ IR ALL IN on the switcher, and use the IR Remote of far-end device to control
the device locally.
1 to 1: (through IR IN)
Connect an IR receiver with IR carrier to the IR IN port of 4K HDBaseT 4x4 Matrix Switcher, users can control
far-end output displayer via its IR remote from local.
In that case, the IR signal is transferred via twisted pair. Only the corresponding IR OUT port can emit control
signals to the remote display.
See the figure below:
Note: The IR receiver connected to IR IN must be with IR carrier
1 TO ALL: (through IR ALL IN)
Connect an IR receiver to the IR ALL IN port of 4K HDBaseT 4x4 Matrix Switcher, the IR signal received from
IR ALL IN port will be transmitted to all the 4 connected far-end HDBT receivers.
See as below:
Note: Send command “%0901.”to enter infrared carrier enforcing mode if the IR Receiver connected to IR ALL
IN is not with carrier.
