www.vanco1.com
800.626.6445
11
REMOTE CONTROL
1. Standby button, press it to enter/ exit standby mode
2. Input channels, range from 1~4 (buttons 5~8 are not available),
corresponding IR signal switched synchronously when switching
input channels.
3. Menu buttons, ALL, EDID and CLEAR, same with the
corresponding front panel buttons. Please refer to Front Panel
Button Control for details.
4. Navigation buttons, ENTER: Confirm button.
5. OUTPUTS (buttons 5~8 are not available) In normal mode: output
channel selection buttons, each channel has 1 IR IN, 1 HDBaseT,
1 RS232, and 1 AUDIO outputs, and channel 1~4 have HDMI
outputs. In EDID invoking mode: press button 1/2 to switch
among the 5 embedded EDID data
Note: With this IR remote, the matrix can be controlled with the
built-in IR sensor, the extended IR receiver connected to the IR EYE/
IR ALL IN, or through the IR receiver on the far-end receiver.
FORCE CARRIER
a) Only if the IR receiver connected to HDBaseT receiver is with IR carrier, can the received IR signal be
transferred to IR OUT port of the matrix.
b) Only if the IR receiver connected to IRALL IN port of the matrix is with IR carrier, can the received IR signal
be transferred to IR OUT port of the matrix.
If the IR receiver connected with HDBaseT receiver or IR ALL IN port of the matrix is not with IR carrier, send
the command “%0901.”to enter infrared carrier enforcing mode, and then IR signal can be transferred to IR
OUT port.
IR CONTROL
