Vanair 050817, Руководство по эксплуатации и список запасных частей

Страница: 45 / 184

AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 2: DESCRIPTION
090019-OP_r0 Page - 23
high pressure air as an automatic feature of the 200
Series machine package. Whenever the pressure in the
air tank drops below 150 psi, the engine will run at full
throttle until the pressure in the 30 gallon capacity
standard tank reaches 175 psi.
The compressor unit features:
• Heavy Duty Stainless Steel Valves - Lapped to
optical flatness for high efficiency and extended wear. All
valves are oversized and designed for high flow.
• Cast Iron Cylinders - precision bored for high
performance and low oil carry-over.
• Suction Valve Head Unloaders - for continuous
running air compressors, unloader lets unit idle load-free
until air supply drops to cut-in pressure; automatically lets
unit idle again after high pressure limit is reached.
• Rings - long-life industrial design compression and oil
control rings for maximum performance.
• Large Intake Filter Silencers -for quiet operation and
provides maximum particulate protection.
• Deep Finned Cylinders and Heads - ensure cool,
vibration free operation and long life.
• Cast Iron High Tensile Strength Rods - with
replaceable rod bearings and pin bushings. Machined to
close tolerances for many years of service.
• Large Main Roller Bearings - precision fit to hold
alignment of all rotating parts.
• Cast Iron Crackcase - for strength and durability.
• Oil Sightglass - conveniently located for reading of oil
level in crankcase.
• Ductile Iron Crankshaft - dynamically balanced,
precision-machined, and ground. Assures extended
running life for all internal bearings and wearing surfaces.
• Balanced Flywheel - for smooth operation with high
volume airflow to cool heads and cylinders.
2.2.2 AIR INTAKE / AIR FILTER
See Figure 2-3 . The air inlet filter is integrated into the
compressor assembly. The air filter element is a dry type
replaceable assembly that drops into the air inlet canister
body, which clamps to the compressor cylinder head. Air
is introduced into the unit via intake vents located on
each side of the bottom of the filter body. For routine
maintenance of the air filter, consult
Sections 6.2 and 6.3