Vanair 050817, Руководство по эксплуатации и список запасных частей

Страница: 104 / 184

SECTION 6: MAINTENANCE AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
PAGE - 82 090019-OP_r0
6.5.7.5 COMPRESSOR BELT LINK
DISENGAGEMENT
Refer to Figure 6-13 , and the following procedure:
1. Hold belt tab-side up with one hand; bend
back as far as possible to expose tab [ B
1
].
2. With the tab now turned parallel to the slot,
push down on the tab [ C ] while pulling up on
the link’s end [ D ].
3. Rotate the belt end with tab [ B
2
] so that the
tab is turned parallel to the slot.
TOOLS NEEDED
REPLACEMENT
PART(S)
Optional Long-Nosed Pliers Compressor
Drive Belt No.
DR270814 (2)
KEY DESCRIPTION KEY DESCRIPTION
A COMPRESSOR PULLEY D OUTER SIDE OF BELT TRACK - Arrows printed
on links point in the same direction as compres-
sor pulley direction of rotation arrow [B]
B COMPRESSOR PULLEY DIRECT OF
ROTATION ARROW E ENGINE PULLEY
C BELT PLACEMENT - Tabs face inside,
toward pulleys F OVERLAP: Align last two tabs with two holes
Figure 6-12: Compressor Drive V-Belt - Determining Sizing and/or Link Removal
B
A
E
C
D
F
WARNING
Relieve pressure from the compressor
system before performing maintenance
on any components.
WARNING
Before performing maintenance or repair
operations on the machine, ensure that
all power has been removed and locked
out to prevent accidental start-up.