Vanair 050817, Руководство по эксплуатации и список запасных частей

Страница: 87 / 184

AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 6: MAINTENANCE
090019-OP_r0 PAGE - 65
11. Dispose of worn air filter assembly within the
guidelines of all applicable local, regional
and/or federal laws.
6.5.2 COMPRESSOR OIL MAINTENANCE
Consult Section 6.3, Maintenance Schedule Table for
compressor oil maintenance schedule, and refer to
Figure 6-2 and the following procedure to check the
compressor oil.
1. With the machine off, check the level of the oil
in the sight glass as indicated in Figure 6-2 .
2. Locate the fill port [ D ]; unscrew and remove
the compressor oil fill cap.
System Operation Group Manual
Section
Location
Compressor Oil Maintenance 6.5.2 page 65
Compressor Oil Change 6.5.2.1 page 65
TOOLS/ITEMS NEEDED
REPLACEMENT
PART(S)
Compressor Oil (if necessary) ISO68, Non-
Detergent Oil
WARNING
Relieve pressure from the compressor
system before performing maintenance
on any components.
WARNING
Before performing maintenance or repair
operations on the machine, ensure that
all power has been removed and locked
out to prevent accidental start-up.
NOTE
The compressor is factory-filled to full
level (1.75 quarts) of high quality, non-
detergent ISO68 oil.
KEY DESCRIPTION KEY DESCRIPTION
A HIGH OIL LEVEL - Do not fill above the top of the red circle D COMPRESSOR OIL FILL PORT
B CORRECT COMPRESSOR OIL LEVEL - Midway of the sight
glass E CRANK CASE DRAIN PLUG
(1/4” NPT)
C LOW OIL LEVEL - Do not let level drop below bottom of the red
circle
Figure 6-2: Compressor Oil Maintenance
E
B
A
C
D