Vanair 050817, Руководство по эксплуатации и список запасных частей

Страница: 131 / 184

AIR IN ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 7: TROUBLESHOOTING
090019-OP_r0 PAGE - 109
DC GENERATOR (CONTINUED)
Welder and/or battery charger
behave erratically (continued) Connection cables or receptacles are
soiled/contaminated (continued) Untwist and/or straighten out any suspected
cable tensions. Carefully wipe off any
contaminants to receptacle connectors
before re-connecting. Replace any worn or
damaged cables or receptacles. Contact
Vanair
®
Mfg., Inc. Service Department if
behavior persists.
Welding function is not drawing enough
operating power If running more than one function
simultaneously, turn off competing function.
No welder output Fuse at welder field blown Replace the welder field fuse. Refer to
Section 6.6, Servicing the System Fuses
and Circuit Breakers .
Display not working Loose or faulty wiring Check wiring: Loose—secure;
faulty—replace.
Lights do not turn off Battery charge low Flip AC generator switch to bring engine to
high rpm, and charge battery.
AC GENERATOR
No AC generator output Serpentine belt out of position or
malfunctioning Re-situate and adjust belt tension, or
replace belt if necessary. Consult
Section
6.5.7, Replacing and Re-tensioning the
Compressor and/or Generator Drive
Belts
, and its sub-sections.
Loose or faulty wiring Check wiring: Loose—secure ;
faulty—replace.
Circuit breaker blown Replace the circuit breaker. Refer to
Section 6.6, Servicing the System Fuses
and Circuit Breakers .
Low AC voltage Engine speed too low for demand Adjust speed control. Consult Section 6.5.6,
Adjusting the Engine Speed , and the
Engine Operator’s Manual.
High AC voltage Engine speed too high for demand Adjust speed control. Consult Section 6.5.6,
Adjusting the Engine Speed , and the
Engine Operator’s Manual.
7.3 TROUBLESHOOTING GUIDE
Fault/Malfunction Possible Cause Corrective Action