VAN WAMEL PERFECT ZW Series, Инструкция по эксплуатации

Страница: 14 / 69

12
No risks !!!
No experiments with imitation parts, use only original Perfect parts !
1.9.2 In service
When the flail mower starts to vibrate the tractor P.T.O. shaft should be disengaged immediately. Check the condition of the
flail rotor and flails.
Replace broken or damaged parts by original
PERFECT parts.
1.9.3 P.T.O. / flail rotor speed
Always speed up the P.T.O. shaft to the prescribed speed of 540 RPM before starting to cut
1.9.4 Replacement of flails
•
Remove the lock-nuts.
•
Replace flails and also the fixing bolts, lock washers and the lock-nuts.
•
Use always original
PERFECT
parts.
•
Fasten the lock-nuts with a torque of 550 Nm (4.750 inlb).
1.10 Service
Before operating the machine check if all points as stated below have been greased properly. Lubricate as follows:
1.10.1 P.T.O. shaft
- Profile tubes:
Lubricate every 4 hours of operation. The grease nipple is marked
with an arrow.
Wash the profile tubes clean periodically in order to remove dirt
and accumulated contaminated grease.
- Guard tubes:
Lubricate every 25 hours of operation.
- Yoke crosses:
Lubricate every 8 hours of operation the grease nipples.
- Slide pins:
Oil regularly the pin.
- Overrunningclutch:
Lubricate every 8 hours of operation the grease nipples.
1.10.2 Bearing houses / flail rotor
Lubricate every 8 hours of operation. Always use a good
quality ball bearing grease EP-2, or equivalent.
Wipe off excess grease to prevent it reaching the V-belts as oil
and grease cause unnecessary slipping and extra wear.