VAN WAMEL PERFECT ZW Series, Инструкция по эксплуатации

Страница: 13 / 69

11
*** Note: Allow the oil enough time to sink through the bearings.
Wipe off excess oil to prevent it reaching the V-belts as oil and grease cause unnecessary slipping and extra wear.
Refill the gearbox to required oil level and refit the breather. Fill up only to the proper level.
ZW
–
150, ZW
–
180, ZW
–
210: oil contents ± 0,75 liter
ZW
–
240: oil contents ± 1,25 liter
ZW
–
Front: oil contents ± 1,25 liter
To replenish or replace the correct oil, if possible Mobil EP 320 or an equivalent oil.
Viscosity base oil at 40°C 320 Cst.
Temperature range -24°C tot 240°C
Good EP properties.
1.8 V-Belts
A correct V-belt tension is very important and must be checked prior to use and after 2, 8
and 16 hours for proper adjustment. Thereafter you should check the tension at regular
intervals, at least every 50 hours.
The V-belts do have the right pré-tension when can displace the V-Belts (one by one)
7,5mm with a force of 8kg (what you can push with your thumb) .
The control opening for the "push-pin" do you find at the rear side of the V-belt housing.
The V-belts of the machine are tensioned a bolt. With this bolt the gearbox is moved
until the correct belt tension is reached. Before changing the V-belts, it must be
completely relaxed.
First loosen the 6 bolts (red arrow) of the gearbox plate, so that it can slide. Then move
the gearbox with the bolt (green arrow) so that the V-belts are tensioned.
Finally retighten the bolts of the gearbox plate.
Remark: When new V-belts are mounted, always make a test run and check the V-belt tension again!!!
1.9 Flails
1.9.1 General
•
Only using original Perfect parts will assure you of a safe service of the flail chopper. So use by replacement only
original
PERFECT parts.
•
Every time before the machine is taken in service the flails should be checked. Are no flails lost? Replace the flails if
necessary by original Perfect parts, see also chapter 1.9.4.
•
Check if the flails are not broken or cracked.
•
When the fixing bolts have to be replaced you should always use original Perfect bolts M20 x 90, quality 10.9.
•
Use the original Perfect lock washers and fasten the lock-nuts with a torque of 550 Nm (4.750 inlb.).
•
The flails have to be replaced when there is no longer any overlap.