Van Der Stahl V-460 Series, Руководство по эксплуатации, Страница: 18 / 76

V-460/610 Series Operating Instructions Ver.2.04E
18
Insert an air pedal hose securely into the elbow of the
main frame air switch located on the left side of the
machine.
The table height and angle can be adjusted by changing
the table mounting position to the angle bars with holes.
■ Attach/remove a table
1 Hold a table with both hands.
2 Press the push buttons on both sides of the table
with your forefingers and put them to holes of
angle steels. Please make sure to set the table to
the preferred height by changing hole position.
3 When removing the table, press the push
buttons with your forefingers and pull the table
towards you to remove.
■ Adjust table angle with drop pins
1
Set drop pins of the table legs on both sides of
the table to the holes of angle steels. By
changing the level of holes, you can adjust the
table angle.
2 Removing the drop pins is the reverse of the
installation procedure. Remove the drop pins
from the holes while pushing them inside.
7-3 Set an air pedal
7-4 Attach/remove the table and how to
adjust its height and angle
Angle steel
with holes
Push inside
Height adjustment range Angle adjustment range
Push button
Drop pin
Table leg
Air hose
Body frame air switch
with elbow joint
Securely insert
the hose
Warning
Make sure to securely set the push buttons
and drop pins to the angle steels;
otherwise, the table may drop or tilt
obliquely by a small impact resulting in
injury.
TIPS
It is easier to set the drop pins one at a
time than to set both pins at the same
time.
Attention
Install the table buttons and drop pins on
both sides at the same level.