VALMETAL H Series, Руководство оператора и каталог запасных частей

Страница: 28 / 86

OPERATION
24
7
. Starting machine:
a. Clear the area of bystanders.
IMPORTANT
Be sure the winch has been
released so the baffles are free to
extend and move the bale during
operation.
b. Place all controls in neutral and set park brake
before starting tractor.
c. Start tractor engine.
d. Use the hydraulics to raise the rotor grate to its
highest position (cylinder rams completely
retracted).
e. While the tractor is running at low idle engine RPM,
slowly engage the PTO control.
e. When fully engaged, gradually increase the engine
speed until the PTO is running at 540 RPM. Always run
at 540 RPM to obtain the most efficient operation.
f. Lower the rotor grate until you obtain the desired cut.
8. Stopping machine:
a. Raise the feeding grate to its highest position and run until the rotor, auger and blower have
cleared themselves of all material. Allowing them to clear themselves will minimize the chance of
the blower plugging when starting the next time.
b. Slow the engine speed to low idle RPM.
c. Slowly disengage PTO clutch.
d. Stop tractor engine and remove ignition key before dismounting.
e. Retract the tub baffles if the tub is empty.
f. It is recommended that the tub be emptied prior to shutdown. This will minimize start-up problems.
WARNING
Do not enter the tub when the trac-
tor engine is running. Keep others
out.
Fig. 16 ROTOR GRATE