VALMETAL H Series, Руководство оператора и каталог запасных частей

Страница: 19 / 86

4.3 BREAK-IN
Although there are no operational restrictions on the
machine when used for the first time, it is recom-
mended that the following mechanical items be
checked:
A. Before starting:
1. Read the Operators Manual and all safety
decal before starting.
B. After grinding 2 bales:
1. Tighten all wheel bolts to their specified
torque. (90 ft. - lbs.)
2. Tighten all fastener to their specified torque.
3. Check oil spacing of all belt and chain
tension springs.
4. Check condition of sections. Straighten or
replace as required.
5. Check and remove any material entangled
in the rotor, auger or blower.
6. Check the oil level in the gearbox. Add as
required.
7. Check that no hydraulic lines are being
pinched or crimped. Reroute as required.
8. Lubricate PTO driveline.
C. After grinding 10 and 50 bales:
1. Tighten all wheel bolts, fastener and other
hardware to their specified torque.
2. Check tension of all belts and roller chains.
Adjust as required.
3. Check condition of sections. Repair or
replace as required.
4. Check and remove any material entangled
in the rotor, auger or blower.
5. Check condition of hydraulic components.
Tighten fittings or reroute as required.
6. Check the oil level in the gearbox. Add as
required.
7. Lubricate all fittings and give sealed bearings
only 1 shot of grease gun.
8. Then go to the normal service schedule as
defined in the Maintenance section.
OPERATION
15