Pag 22
Position
X Cut Ad and Y Cut Ad adjust position of image in X direction and Y direction separately.
Refer to below picture for better understanding.
Corner cutting control
“
Rotary Rad (Turn Radius)
” parameter means corner moving radius. Knife has a cutting tip with a certain angle, a little apart from
the center of cutting knife holder. This makes errors in moving around the corners. This parameter setting helps smooth cutting at
the corner as good as possible. See below picture to understand better.
Speed and Acceleration control
Speed and acceleration can be very sophisticatedly controlled in Duo-Blade F. These parameters are dependent to the shape and
complexity of cutting design itself. Acceleration means how fast to each to the target speed from starting point or hot fast to stop
cutting at end point. Speed and acceleration can be differently setup for straight lines and curves. Be sure to use less values of
Bend Speed when cutting circles. Even it is possible to setup acceleration at starting of curves from straight lines. Feeding speed
by suction belt can be adjusted separately.
Caution
If you are cutting small circles and the result is not smooth, you need to slow down the
Bend speed
.
It would be also helpful to slow down
CUT SPEED together.
