Vaisala WXT510, Руководство пользователя

Страница: 61 / 101

Chapter 7 ___________________________________________________ Getting the data messages
VAISALA________________________________________________________________________ 61
where
$ = Start of the message
WI = Talker identifier (WI=weather instrument)
XDR = Transducer measurement response identifier
C = Transducer id 2 type (Heating temperature), see the
following Transducer table
25.5 = Transducer id 2 data (Heating temperature)
C = Transducer id 2 units (C, Heating temperature)
2 = Transducer id for Heating temperature
U = Transducer id 0 type (Heating voltage)
10.6 = Transducer id 0 data (Heating voltage)
N = Transducer id 0 units (N=heating disabled or heating
temperature too high
1
, Heating voltage)
0 = Transducer id for Heating voltage
U = Transducer id 1 type (Supply voltage)
10.9 = Transducer id 1 data (Supply voltage)
V = Transducer id 1 units (V, Supply voltage)
1 = Transducer id for Supply voltage
U = Transducer id 2 type (3.5V reference voltage)
3.360 = Transducer id 2 data (3.5V reference voltage)
V = Transducer id 2 units (V, 3.5V reference voltage)
2 = Transducer id for 3.5V reference voltage
* CRC delimiter
71 = A two character CRC for the response.
<cr><lf> = Response terminator
1
See section Supervisor message for definitions of the Heating
voltage field.
Transducer table
Transducer Type Units field Comments
Temperature C C= Celsius
F= Fahrenheit
Angular displacement A D=degrees
Wind speed S K=km/h, M= m/s N=knots S=mph, non-standardized
1
Pressure P B=bars, P=Pascal H=hPa, I=inHg, M=mmHg
Humidity H P=Percent
Precipitation V M=mm, I=in, H=hits non-standardized
1
Time (duration) Z s=seconds non-standardized
1
Intensity (flow rate) R M=mm/h, I=in/h, H=hits/h for rainfall
M=hits/cm
2
h, I=hits/in
2
h, H=hits/h for hails
non-standardized
1
Voltage U V=volts (also 50% duty cycle for heating) N=not in use, F=50% duty
cycle for heating, W= full
power for heating
1
Not specified in the NMEA 0183 Standard.