User's Guide ______________________________________________________________________
32 __________________________________________________________________ M210934EN-B
Select Unit
Use the
UNIT
command to select metric or non-metric output units.
UNIT
[
x
]
where
x
=
M or N
where
M = Metric
units
N = Non-metric
units
Set Serial Interface Mode
Use the
SMODE
command to set the default serial interface mode.
SMODE
[
xxxx
]
where
xxxx
= STOP, RUN or POLL
In STOP mode:
measurements output only by command SEND, all
commands can be used
In RUN mode:
outputting automatically, only command S can be
used to stop.
In POLL mode:
measurements output only with command SEND
[
addr
].
When several transmitters are connected to the same line, each
transmitter must be entered an own address in the initial configuration,
and POLL mode must be used.
Configuring Measurement Parameters
Select Analog Output Quantity and
Scaling
Select and scale the quantities for the analog outputs with the
ASEL
command. Note that the optional quantities can be selected only if they
have been selected when ordering the device.
