Chapter 4 ________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 77
5.
In the IP configuration menu, select
Automatic configuration
(DHCP)
, or enter the
IP address
,
Netmask
and
Gateway
manually. If automatic configuration is enabled, manual
configuration cannot be done.
0709-004
Figure 50
IP Configuration Menu
To enter a value manually, use the the
▲▼
arrow buttons to select
the parameter to change, and press
Change
. A cursor will appear in
the first digit. Move the cursor using the
◄►
arrow buttons, and
change the value under the cursor using the
▲▼
arrow buttons.
Confirm the selection by pressing
OK
.
6.
After configuring the desired parameters, press
EXIT
to return to
the basic display.
Using Serial Line
Use the serial line command
NET
to view or set the network settings for
the LAN and WLAN interfaces. You can also refresh the network
information or disconnect all active connections.
NET
[
REFRESH
]
[
DISCONNECT
]
[
DHCP WEB
]
[
DHCP IP SUBNET
GATEWAY WEB
]
where
REFRESH =
Updates
the
network
information and displays it.
DISCONNECT = Disconnects all current sessions.
DHCP
=
ON or OFF. Enables or disables the automatic IP
configuration.
WEB
=
ON or OFF. Enables or disables the Web
Configuration page.
IP
=
The four part network ID of the transmitter. Must
be set manually if automatic configuration is not
used.
SUBNET
=
Used together with the IP address to determine
which network the transmitter is a part of. Must be
set manually if automatic configuration is not
used.