IT
ALIANO
- 16 -
3
2
-Cnt
tot
SEru
ESC
-01.3
-02.0
-01.0
-03.0
1
0 12.
.45 1
11 - LETTURA DEL CONTATORE DI CICLI
La centrale PD22 tiene il conto dei cicli di apertura completati e, se
richiesto, segnala la necessità di manutenzione dopo un numero
prefissato di manovre.
Sono disponibili due contatori:
• Totalizzatore non azzerabile dei cicli di apertura completati
(opzione
tot
della voce
Cnt
)
• Contatore a scalare dei cicli che mancano al prossimo
intervento di manutenzione (opzione
SErv
della voce
Cnt
).
Questo secondo contatore può essere programmato con il
valore desiderato.
Per accedere al menù seguire le seguenti indicazioni:
1.
Mantenere premuto il tasto
OK
fino a quando il display
visualizza
-Cnt
2.
Rilasciare il tasto
OK
: il display visualizza
tot
11.1 - CONTATORE TOTALE DI CICLI
L’area 1
rappresenta la lettura del conteggio totale di cicli
completati: con i tasti
h
e
i
è possibile alternare la visualizzazione
delle migliaia o delle unità.
11.2 - SEGNALAZIONE DELLA
NECESSITÀ DI MANUTENZIONE
Quando il contatore dei cicli mancanti al prossimo intervento di
manutenzione arriva a zero, la centrale segnala la richiesta di
manutenzione mediante un prelampeggio supplementare di
5 secondi.
La segnalazione viene ripetuta all’inizio di ogni ciclo di apertura,
finchè l’installatore non accede al menu di lettura e impostazione
del contatore, programmando eventualmente il numero di cicli
dopo il quale sarà nuovamente richiesta la manutenzione.
Se non viene impostato un nuovo valore (cioè il contatore viene
lasciato a zero), la funzione di segnalazione della richiesta di
manutenzione è disabilitata e la segnalazione non viene più
ripetuta.
m
ATTENZIONE: le operazioni di manutenzione devono
essere eseguite esclusivamente da personale qualificato.
L’area 2
rappresenta la lettura del numero di cicli mancanti al
prossimo intervento di manutenzione: il valore è arrotondato alle
centinaia.
L’area 3
rappresenta l’impostazione di quest’ultimo contatore:
alla prima pressione del tasto
h
o
i
il valore attuale del contatore
viene arrotondato alle migliaia, ogni pressione successiva fa
aumentare l’impostazione di 1000 unità o diminuire di 100.
Il conteggio precedentemente visualizzato viene perduto.
Lo schema che segue illustra la procedura per leggere il
totalizzatore, leggere il numero di cicli mancanti al prossimo
intervento di manutenzione e programmare il numero di cicli
mancanti al prossimo intervento di manutenzione (nell’esempio
la centrale ha completato 12451 cicli e mancano 1300 cicli al
prossimo intervento.
Содержание ATRIS-700
